PERFORM A QUICKSTART ANALYSIS
Unit [n] > QuickStart Analysis
In 21CFR11 environments, users are required to login to the Confirm application to
start an analysis. Once the analysis window is opened, manual control is disabled
until the analysis has completed. During analysis, pausing and resuming is allowed,
however, steps cannot be skipped.
Use to analyze up to three samples of the same type using the same analysis conditions,
adsorptive properties, and report options. The QuickStart Analysis option automatically creates a
sample file for each port and assigns the default parameters. Edit the parameters of a file using
the Edit button or select another file using the Browse button.
Click Next to schedule additional analyses after the completion of the first set of analyses. The
Next button appears after the first series of analyses is complete. Samples cannot be removed or
added to ports until the full set of analyses has completed.
1. Click Browse to select a sample file.
2. Click Report after analysis to automatically generate reports when the analysis is com-
plete. On the Report Settings window, select the report destination. Click OK.
3. Click Start to start the analysis. A window displays data as they are collected. A short delay
is encountered before the port status changes from the Idle state at the bottom of the
window. When analysis is complete, remove the sample tube and store (or dispose) of the
sample material as applicable.
4. Click Start to start the analysis. A window displays data as they are collected. A short delay
is encountered before the port status changes from the Idle state at the bottom of the
window. When analysis is complete, remove the sample tube and store (or dispose) of the
sample material as applicable.
Perform a QuickStart Analysis
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023
6 - 15
To Next Page
Loading...
Need help?
General
