10 CALIBRATION
Unit [n] >Calibration
A calibration file was created specifically for the analyzer and included with the
accessories. It is not necessary to recalibrate the system unless it seems out of cal-
ibration.
Disabled calibration menu options can be accessed only with the assistance of an authorized
Micromeritics Service Representative. Calibrations can be saved to a file and reloaded later.
To review calibration details of the analyzer, go to Unit [n] > Unit Configuration.
Generally, it will not be necessary to change the data in the calibration file. However, if a condition
occurs during the operational verification that requires changes to the calibration data, changes
should be saved in a file. Calibration data files are retained in the analyzer history file and can be
reloaded in the event that calibration data becomes corrupt.
10 Calibration
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023
10 - 1
To Next Page
Loading...
