Micromeritics TRISTAR II PLUS - Selected Report Options; T-Plot Report Configuration

T-PLOT REPORT
The t-Plot calculation allows quantitative analysis of the area and total volume ascribed to
micropores. Matrix area (the area external to micropores) is directly determined and often proves
to be a valuable way of characterizing complex mixed materials.
Selections
Description
Fitted thickness range
[textbox]
Enter the minimum and maximum thicknesses (in angstroms or nano-
meters) to include in the thickness curve. Go to Options > Units to
specify default units.
Pressures [button]
Use to select a pressure range for report calculations and points for
exclusion from calculations.
Calculation pressure range. Enter the minimum and maximum
pressures to be used in the pressure table.To exclude a point from
the calculations used to generate the report, select Exclude.
Exclude All.Select to exclude all pressure points in the table.
Include All.Select to include all pressure points in the table.
t-Plot Report
t-Plot Report
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023
8 - 51