LOAD CALIBRATION FROM FILE
Unit [n] > Calibration > Load from File
Use to load a previously saved calibration file.
It is recommended that the current calibration settings be saved using Unit [n] > Calibration >
Save to File prior to loading another calibration file. When loading a previously saved calibration
file, a backup of the current file is created and saved as [SN]last.cal. The backup file is overwritten
each time a new one is created.
Changing the calibration may affect the analyzer’s performance.
Load Calibration from File
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023
10 - 5
To Next Page
Loading...
