Micromeritics TRISTAR II PLUS - Page 119

Selections Description
Insert Range. Specifies the starting and ending quantities adsorbed
and number of points to insert.
Load Table. Imports values from another file.
Save Table. Saves the current table as a .QNT file.
Apply. Applies all table changes.
Heat of adsorption plot
[selection]
Generates the Heat of Adsorption data in a graphical format.
Isostere plot [selection]
Generates a graph showing quantities of gas adsorbed versus the
temperature.
Remove Sample
[button]
Removes the selected sample from the list.
Show graphic
[checkbox]
Use to show a graphic on the report header.
Height/Width. Enter the height and width of the selected graphic.
These values determine the graphic's appearance on the generated
report.
Show report title
[checkbox]
Select then enter a report title to appear on the report header.
Tabular report
[checkbox]
Generates a tabular report of the included samples that contains the
numeric values contributed by each sample.
For fields and buttons not listed in this table, see Common Fields and
Buttons on page2 - 3.
Heat of Adsorption Report (continued)
Heat of Adsorption Report
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023
7 - 3