Micromeritics TRISTAR II PLUS - Analyzer Components Overview; Electrical Specifications; Computer System Requirements

Voltage 100-240VAC
Power 150VA, maximum
Frequency 50/60Hz
Overvoltage category II
Electrical
Operating System
Windows 10 or higher operating system is required. For 21 CFR
Part 11 environments, Windows 10 Professional or Windows 10
Enterprise or higher is required.
Desktop Installation
Required
The application should not be installed on a network drive with
shared access.
Multiple users cannot operate the application at the same time.
Ensure the "Sleep" setting on the desktop is set to
"Never" to avoid interruption while running an analysis.
If this occurs, the application loses network
connectivity with the instrument and a communications
error will be reported. Arestart of the Windows
application may be required if automatic reconnection
is not successful.
10 Base T or 100 Base T
Ethernet Port
If the computer is to be connected to a network, two Ethernet ports
are required. If more than one Ethernet-based unit is connected to
the same computer, an Ethernet switch will also be required. If a
Smart VacPrep is to be used, an Ethernet switch is required.
Read/Write Permissions
All application users will need Read/Write permission to all
directories and subdirectories where the application is installed.
For 21 CFR Part 11 environments, permission may be limited to
the installation directory.
Drives USBport
Computer Requirements
Due to continuous improvements, specifications are subject to change without notice.
Specifications for the TriStar IIPlus
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023
1 - 9