Micromeritics TRISTAR II PLUS - Page 85

Selections
Description
[checkbox]
analyses.
Inside diameter of sample tube. Enabled when Apply thermal
transpiration correction is selected. Enter the inside diameter of the
sample tube used in the analysis.
Refer to the Thermal Transpiration Correction section of the
Calculations document.
Overlays [button]
See Graph and Sample Overlays on page7 - 27.
Report options
[drop-downbox]
Browse for a .RPO file that contains report options parameters to be
used in the report.
Selected Reports
[groupbox]
Select the report names to include in the report. For BJH reports, BJH
pore dimension can be calculated in pore width (w), pore radius (R), or
pore diameter (D). Go to Options > Units to specify default
calculations.
Show graphic
[textbox]
Use to show a graphic on the report header.
Height/Width. Enter the height and width of the selected graphic.
These values determine the graphic's appearance on the generated
report.
Show report title
[checkbox]
Select then enter a report title to appear on the report header.
For fields and buttons not listed in this table, see Common Fields and
Buttons on page2 - 3.
Report Options (continued)
Report Options
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023
4 - 17