Milnor MilTouch - Data Transfer with the MilTouch Controller

Pellerin Milnor Corporation 99
• Touch
to select the root of the USB flash drive as the destination for the files.
• Touch
to select the SD card as the destination for the files.
8. Touch
to export the file. The file appears in the External Data Area.
9. A dialog box (not shown) appears, which indicates the file was exported. Touch
to dis-
miss the dialog box.
10. If you exported files to a USB flash drive, touch
to unmount the flash drive. The avail-
able media indicator in the bottom right of the Data Transfer display changes from green to
red
, which indicates the controller no longer recognizes a connected USB device.
11. Remove the USB flash drive.
5.2.3 How to Import Files to the MilTouch™ Controller
BNCLJO06.T13 0000194298 E.2 E.5 10/7/20 9:25 AM Released
To import wash formulas and configuration files to the MilTouch™ machine controller from a
USB flash drive or from the SD card:
NOTE: Wash formulas can be imported to one or more MilTouch™ machines, but you
should only transfer wash formulas between machines with similar or identical model
numbers, equipment, and configuration.
NOTE: Your machine was configured with the optimum or required settings at the fac-
tory. Configuration files can be imported to one or more MilTouch™ machines, but this is
not recommended. Save a backup copy of each machine’s configuration file for restora-
tion to that machine only, if necessary in the future.
1. Touch
on the Home display to access the Data Transfer display.
2. If you are importing files from a USB flash drive, mount the flash drive to the MilTouch™
controller as described in Section 5.2.1 , page 97. If there is already a flash drive attached to
the controller, remove and re-insert it.
3. Choose to import the files from either the USB flash drive or the SD card in the controller. In
the External Data Area:
• Touch
to select files from the root of the USB flash drive.
• Touch
to select files from the SD card.
4. Choose to import either wash formulas or configuration files. In the Internal Data Area:
Data Transfer