Pellerin Milnor Corporation 95
NOTE: The formula groups feature is only available on machines running the software
versions listed in Table 12, page 95, or later software versions, on both the machine con-
troller and the PC programmer application. If you are running an older version of the PC
programmer application, you must uninstall it, then re-install the latest version. Your for-
mulas and configuration settings from the old version will be retained on the new version
of the programmer application.
Table 12. Formula Group Software Versions
Controller Variation Software Version
MilTouch™ WUMTGUIA / 3.2.100
MilTouch-EX™ WUMTGUIB / 4.2.000
MilTouch-EX™ WTB WUMTGUIC / 6.2.000
5.1.4 The USB Flash Drive Formatting Requirement
BNCLJB02.C06 0000210542 E.2 F.4 D.3 1/2/20 1:22 PM Released
CAUTION: An unreliable USB flash drive — Can prevent data restoration.
� Use only good quality USB hardware.
� Dedicate a USB flash drive to a specific machine or group of
machines.
Before you attach a USB flash drive to your MilTouch™ controller for the first time, format the
drive to make it compatible with the MilTouch™ controller software. To format your USB flash
drive, use the procedure in Section 6.3.1 : Format your USB Flash Drive, page 113.
5.1.5 Data Directory Structure and Files
BNCLJB02.C01 0000210018 E.2 F.4 E.3 11/6/20 2:08 PM Released
When you transfer data either to a personal computer or to a USB drive, a hierarchy of directories
and files similar to that shown in the following table are created.
Table 13. Example of Directory and File Structure After Data Transfer
Directory or File Description
USB Drive (D) USB drive root directory (example). Alternatively, this could be
the root of the large partition on the internal SD card.
36026V7Z-1.cfg Examples of configuration files that you transferred from the ma-
chine. The file names before the .cfg extension are the names
you assigned to these configuration files. These files are propriet-
ary. Only the controller and the PC programmer application can
use these files.
temporary.cfg
L0_Commercial.set The directory that contains the default formulas that you trans-
ferred from the machine. The structure under this directory is not
shown.
Data Transfer
To Next Page
Loading...
