6
Pellerin Milnor Corporation
1 Preface
BNCLDO02 / 2020465
BNCLDO02 0000243630 B.4 11/12/20 11:59 AM Released
1.1 About MilTouch™ Machines, the MilTouch™ Con-
troller, and This Manual
BNCLDO02.C01 0000243626 E.2 B.4 B.5 11/10/20 11:08 AM Released
NOTICE: MilTouch™, MilTouch-EX™, and MilTouch-EX™ WTB are variations of
the same controller design, each of which applies to an exclusive family of washer-extrac-
tors. This manual applies to MilTouch-EX™ WTB software version 6.2.000. This manual
also applies to all consecutively subsequent software versions that do not affect the user
experience described herein.
• For the basic MilTouch™ controller, refer to manual MCCLJB01.
• For the MilTouch-EX™ controller without automated loading and discharge, see
MCCLWB01.
In this manual:
• You will see the term MilTouch™ used to describe features that apply to all three controller
variations.
• You will see the term MilTouch-EX™ used to describe features that apply only to the Mil-
Touch-EX™ and MilTouch-EX™ WTB controller variations.
• You will see the term MilTouch-EX™ WTB used to describe features that apply only to the
MilTouch-EX™ WTB controller variation.
The Milnor
®
MilTouch™ washer-extractor controller uses a touch-sensitive display screen to op-
erate the machine. All the functions and information you need to configure, program, and run the
machine appear on this screen.
CAUTION: Excessive pressure — can damage the display screen.
� Do not push hard on the glass.
� Use only a finger to touch the glass. Do not touch the screen with a
tool.
Operators will use the MilTouch-EX™ WTB controller to initiate automatic loading, washing,
and discharging. However, the MilTouch™ controller also has features that are accessible when
the machine is idle. These features will interest specialists, such as service technicians and chemi-
cal suppliers who work with the machine. These features are the subject of this manual. Refer to
the operator guide for operator instructions.
To Next Page
Loading...
