Pellerin Milnor Corporation 33
3.1.1.10 MilTouch-EX™ Wash Formula Decisions
BNCLUP08.R02 0000197715 E.2 B.3 C.3 1/2/20 1:22 PM Released
Type
End Formula The formula is completed and causes the controller to query for how to end the
formula.
1-Way Wash a bath step in which the cylinder turns in one direction
2-Way Wash a bath step in which the cylinder turns in the two directions. A wash step can be
used to cool down the previous bath. See Section 3.3 : How to Use Cooldown, page 38.
Soak Wash a bath step in which the cylinder does not turn
Staged Extract an extract step specifically applicable to goods such as cotton towels and rub-
ber mats. SeeSection 3.5 : The Sequence of Actions in a Staged Extract (MilTouch-EX™),
page 41 for more information.
Standard Extract an extract step which accelerates cylinder rotation to the speed entered in
the speed decision and maintains that speed for the time entered in the time decision.
Time — Set the hours, minutes, and seconds that the step timer will run before it declares that
this step is complete.
TIP: Some step types start the step timer only after requirements are met, such as water
level. The time required to meet these requirements will increase the total time of the step
and the formula.
Temperature — Set the temperature desired for a bath step. Units are Fahrenheit or Celsius de-
grees, as configured. The valid range is 50 to 205 degrees Fahrenheit (10 to 96 degrees Celsius).
NOTE: The following three step decisions control the temperature of incoming bath
water. You can use the techniques described in Section 3.4 : How to Modulate Water
Valves to Regulate Incoming Water Temperature, page 40 to achieve the fastest possible
fill that also achieves the desired bath temperature.
Hot Water
OFF Do not open the hot water inlet valve while the machine is filling.
ON Use hot water while the machine is filling.
Raise Fill Temperature The hot water valve opens only to increase the bath temperature to the
desired temperature while the machine is filling.
Cold Water
OFF Do not open the cold water inlet valve while the machine is filling.
ON Use cold water while the machine is filling.
Lower Fill Temperature The cold water valve opens only to decrease the bath temperature to
the desired temperature while the machine is filling.
3rd Water
OFF Do not open the 3rd water inlet valve while the machine is filling.
ON Use 3rd water while the machine is filling.
Raise Fill Temperature The 3rd water valve opens only to increase the bath temperature to the
desired temperature while the machine is filling.
Formula Maintenance
To Next Page
Loading...
