Pellerin Milnor Corporation 37
On Time — When a bath step turns in two directions, this is the number of seconds the motor is
ON, turning the cylinder.
Off Time — When a bath step turns in two directions, this is the number of seconds the motor is
OFF, letting the cylinder coast.
Fill from Tank — If the machine is equipped with an overhead tank, fill from the tank for this
step.
Recirculate Water — If the machine is equipped with recirculation piping, circulate the bath
liquor out of the machine, through other devices, and back into the machine.
BNCLDW01 / 2019335
BNCLDW01 0000242816 A.5 1/2/20 1:22 PM Released
3.2 Post-wash Codes
BNCLDO01.C04 0000188684 E.2 A.5 B.9 1/2/20 1:22 PM Released
Post-wash codes are used during automatic operation to pass dry codes and destination codes to
allied (non-Miltrac™) drying or conditioning equipment.
Dry code the drying formula to be used in the drying or conditioning equipment.
Destination the storage location within the laundry to send the load.
NOTE: Your machine must be configured Post-wash = YES to use post-wash codes.
See Post-wash.
Touch
on the Home display and choose Program Post Dry from the selection list to ac-
cess the Program Post Dry display, shown in the following figure.
Figure 15. Program Post-Post Dry Display
Window
Legend
A... The formula associated with
the post-wash code
B... Enter dry code
C...Enter the destination code
D...Add a new post-wash code
E...Delete the selected post-
wash code
Formula Maintenance
To Next Page
Loading...
