Pellerin Milnor Corporation 53
Brake Pads Worn — The brake pads used to slow the cylinder after an extract are worn. Re-
place the pads.
Too Many Recycles — Due to an unbalanced load, the machine has performed the maximum
of three extract cycles. The current extract step will be completed at a speed lower than
programmed.
Check Balance System/Excursion Switch — The balance system or the excursion switch
tripped.
Loading and Discharging Errors — These errors can occur during automated loading
and discharge. When these errors occur, it may be necessary to use manual mode to reposition the
machine.
Loading Aborted — This error occurs when the loading device or another external device
sends a signal to the MilTouch™ machine to abort the loading process.
Discharge Aborted — This error occurs when the discharge device or another external device
sends a signal to the MilTouch™ machine to abort the discharging process.
Invalid Formula — The operator programmed the MilTouch™ machine to use a wash formula
that does not exist in the Mildata
®
computer.
Load Eye Blocked — This error indicates that the load chute photoeye is blocked, which sug-
gests there is a jam in the load chute.
Up Lock Not Made — The controller cannot confirm that the chute is in the up and locked
position.
Invalid Work Order — The operator entered a work order that does not exist in the Mildata
®
computer.
Invalid Goods Code — The operator entered a goods code that does not exist in the Mildata
®
computer.
Invalid Customer Code — The operator entered a customer code that does not exist in the
Mildata
®
computer.
Invalid Employee Code — The operator entered an employee code that does not exist in the
Mildata
®
computer.
Can't Find Data — This error appears only on machines connected to a Mildata
®
computer.
The MilTouch™ machine requested a wash formula that was not found on the Mildata
®
computer.
Troubleshooting
To Next Page
Loading...
