Milnor MilTouch - Main Configuration Decisions

14
Pellerin Milnor Corporation
• A window does not appear. Touch the decision to toggle between enabled (YES ) and
disabled (NO
).
• Save or abandon your changes:
– To abandon the most recent changes and return to the Home display, touch
.
– To save the changes and return to the Home display, touch
.
NOTE: The configuration changes you make are recorded in the data logs. See Section
4.2.3 : Configuration and Programming History, page 44.
2.1.3 Main Configuration Decisions
BNCLDP01.R02 0000249060 E.2 C.2 B.2 11/8/21 4:49 PM Released
Use the following information to configure the controller based on your machine’s features and
specifications, as well as your laundry needs.
The configuration decisions that are hardware-dependent are marked “Avoid modification” in the
following explanations. A few configuration decisions are not hardware-dependent, but it is im-
portant to understand the consequences of changing these values, as explained.
Temperature Unit — Select the unit, either degrees Fahrenheit or degrees Celsius, that the con-
troller uses to measure and display the bath temperature.
This decision also determines the water unit for bath steps in which the water level is controlled
by a pressure transducer.
• If the temperature unit is degrees Fahrenheit, the water unit is inches.
• If the temperature unit is degrees Celsius, the water unit is centimeters.
NOTICE: The numerical values for water levels do not automatically change to reflect
a change in the temperature unit (and therefore a change in the water unit). For example,
if water level 1 is set to 13.0 inches and you change the temperature unit to Celsius (thus
changing the water unit to centimeters), the water level will be 13.0 centimeters, not
33.02 centimeters (the correct converted value). If you change the temperature unit, you
must also manually change the water level 1, 2, and 3 values, as well as all user-defined
levels, to reflect the unit change.
Configuration