Milnor MilTouch - To Delete a Step

Pellerin Milnor Corporation 31
NOTE: The controller prevents the duplication of an extract step. This prevents two
consecutive extract steps.
1. Use
and on the Steps in a Wash Formula display if necessary to scroll between
pages and show the step you want.
2. Touch the button that displays the step name (Sn).
3. Touch
to copy the step. The controller prompts you to choose where it will insert the
copy of the step:
• before the original step
• after the original step
• at the end of the formula
The controller gives the copy of the step a name similar to (Copy) Step xxx, where Step
xxx is the name of the step you copied.
4. Touch
to change the step name. The Step Name window (not shown) appears. In the
Step Name window:
a. Touch the [Clear All] button to delete the step name that the controller provided.
b. Use the keypad to enter a new step name.
c. Touch
to save the new step name.
3.1.1.8 To Delete a Step
BNCLJO06.T24 0000197446 E.2 B.3 D.3 1/2/20 1:22 PM Released
Delete a step from a wash formula.
NOTE: The controller prevents the deletion of a step if the result would be two consec-
utive extract steps.
1. Use
and on the Steps in a Wash Formula display if necessary to scroll between
pages and show the step you want.
2. Touch the button that displays the step name (Sn).
3. Touch
to delete the step.
4. A dialog box (not shown) appears, which prompts you to confirm your decision. On the dia-
log box, touch
to delete the step.
Formula Maintenance