38
Pellerin Milnor Corporation
3.2.1 How to Add a New Post-Wash Code
BNCLDO01.T02 0000242698 E.2 A.5 A.8 1/2/20 1:22 PM Released
1. On the Program Post Dry display, touch . The Add Post Dry window (not shown)
appears.
a. In the Add Post Dry window, enter the formula that will use the post-wash code. The
controller will send the post-wash code to the dryer every time the machine runs this
formula.
b. Touch
to create the post-wash code for that formula.
NOTE: You cannot change the formula assigned to the post-wash code after you
touch
.
2. Touch the button labelled “DryCode” (item B in Figure 15, page 37). The Post Dry Drycode
window (now shown) appears.
a. In the Post Dry Drycode window, enter the dry code.
b. Touch
to confirm your entry and close the window.
3. Touch the button labelled “Destination” (item C in Figure 15, page 37). The Post Dry Desti-
nation window (not shown) appears.
a. In the Post Dry Drycode window, enter the destination.
b. Touch
to confirm your entry and close the window.
BNCLJP01 / 2019442
BNCLJP01 0000185773 E.3 10/28/19 2:36 PM Released
3.3 How to Use Cooldown
BNCLJP01.C20 0000199666 E.2 E.3 D.3 1/2/20 1:22 PM Released
A cooldown bath is used to gradually lower the temperature of goods (usually synthetics and
blended fabrics) to reduce the chance of setting wrinkles.
3.3.1 Configure your Machine for Cooldown
BNCLJP01.C21 0000201178 E.2 E.3 D.3 1/2/20 1:22 PM Released
To use cooldown, your machine must be equipped with and configured for:
• A separate cooldown water valve.
• A temperature probe/sensor (Temp Probe = YES).
• Cooldown enabled (Cooldown Error = 05 Minutes, 10 Minutes, or 20 Minutes).
See Section 2.1 : Machine Configuration, page 12.
Formula Maintenance
To Next Page
Loading...
