54
Pellerin Milnor Corporation
Chute Door Not Closed — This error appears only on machines equipped with a separate
load chute and door. The machine controller cannot confirm that the load chute door is com-
pletely closed.
Bifold Door Not Closed — The machine controller cannot confirm that the bifold door is
completely closed (the “Bifold Door Closed” input did not actuate when the machine expected
it).
Bifold Door Not Open — The machine controller cannot confirm that the bifold door is fully
open for loading (the “Bifold Door Full Open” input did not actuate when the controller expected
it).
Can't Find Load Position — The "Load Position" input was not actuated within the required
time limit.
Can't Find Wash Position — The “Wash Position” input was not actuated within the required
time limit. This error also occurs when the machine attempts to tilt to the discharge position (in-
stead of the wash position) before an extract.
Can't Find Unload Position — The "Rear Full Up" input was not actuated within the required
time limit.
Chute Locked Up — Indicates the automatic loading chute is locked in the up position.
Chute Locked Down — Indicates the automatic loading chute is locked in the down position.
Load Eye Not Blocked — Goods did not block the load chute photoeye when the machine
controller expected a load.
Door Opened — Indicates the chute is not completely against the machine and sealed.
4.3.2 Error Correction
BNCLJT05.C01 0000304574 E.2 C.2 A.9 9/11/20 3:52 PM Released
Touch (in the error code dialog box, Figure 22: Sample Error Code Dialog Box, page 49 )
to view the Error Causes/Solutions display (shown in the following figure).
The Error Causes/Solutions display gives a list of possible causes for the error. Touch one of
the error causes in the list for an explanation of how to correct it.
Some errors do not have additional details on how to solve them.
Troubleshooting
To Next Page
Loading...
