Milnor MilTouch - Page 83

Pellerin Milnor Corporation 81
Table 8 Outputs on 24-Output Board #1 (cont'd.)
Output #
(Board)
Output #
(Display)
Connections on
Board
Function
Description
2 10 1MTA13-3 & 13-13 Door Unlock
Actuate to unlock the
door.
3 11 1MTA13-4 & 13-14 Clockwise
Actuate to rotate the cyl-
inder clockwise at wash,
drain, or extract speed.
4 12 1MTA13-5 & 13-15 C-clockwise Wash
Actuate to rotate the cyl-
inder counterclockwise at
wash speed.
5 13 1MTA13-6 & 13-16 Steam Valve
Actuate to open the steam
valve.
6 14 1MTA13-7 & 13-17
Operator Signal
Actuate to sound the op-
erator signal.
7 15 1MTA13-8 & 13-18
3-wire Relay
Actuate to enable the 3-
wire circuit. Must also
pulse the 3-wire pulse
output to complete
circuit.
8 16 1MTA13-9 & 13-19 Brake Release
On machines equipped
with a mechanical brake,
actuate this output to re-
lease the brake during the
wash cycle.
9 17 1MTA13-10 & 14-1 Hot Water
Actuate to open the hot
water inlet valve.
10 18 1MTA14-11 & 14-2 Cold Water
Actuate to open the cold
water inlet valve.
11 19 1MTA14-12 & 14-3 Third Water
Actuate to open the op-
tional third water inlet
valve.
12 20 1MTA14-4 & 14-13 Drain Solenoid
Actuate to open the drain
valve to the sewer.
13 21 1MTA14-4 & 14-14 Reuse Drain
Actuate to open the op-
tional reuse drain valve.
14 22 1MTA14-10 & 14-5 Machine to Machine
Actuate to recirculate
drained bath water back
into the machine.
15 23 1MTA14-10 & 14-15 Machine to Tank
Actuate to drain bath
water from the machine
to the overhead tank.
16 24 1MTA14-10 & 14-6 Push-down
Actuate to secure hydro
cushion machines in the
wash/drain position.
Troubleshooting