4-12
9
Select the Image Edit tab of Raster Link Pro5,
and set the print condition.
• Set the print condition for the media type selected on the Step 5.
When translucent media is selected on the Step 5
Select [Translucent Back side] on [Double sided printing] of Raster Link Pro5.
When opaque media is selected on the Step 5
Select [Opaque Back side] on [Double sided printing] of Raster Link Pro5.
10
Select the profile for backside on Print Condition tab, and click [OK].
11
Start printing on Raster Link Pro5.
• Right-click the image to print, select [RIP and Print] or others, and start printing.
For details, see Reference Guide (Common features for every printer) of Raster Link Pro5.
• When printing on back side, the following settings are fixed.
12
When the printer receives the data for backside-print, it prints Misalignment check
line for scan direction.
• If the different media type from the selected one on the Step 5 is set and printed, an error
appears on the printer and the printer does not print.
About profile to be selected for printing on back side
• When printing on the back side of translucent media, select the following profile.
4-color ink set: 360 x 360, 1 pass
6-color ink set: 360 x 360, 2 pass
• When Translucent Back side is selected on RasterLinkPro, selecting the mode other than
above displays an error.
• When printing on the back side of opaque media, select device profile that is used for normal
printing.
• If a profile for translucent media (360 x 360 dpi) is selected while opaque media is selected, it
cannot print with the specified size.(If a profile for translucent media is used, the printer starts
printing by Raster Link Pro5, then printer displays parameter error, and it prints the rest by fixed
mode (720 x 720, 8pass).
Setting Fixed value Setting Fixed value
Right and left margin
(in the effective print area)
0mm
Stamp OFF
Setting of media feed Normal
Color pattern OFF Pre-feed OFF
Setting of crosswise origin by jog key invalid WhiteLay Print OFF
To Next Page
Loading...
