MIMAKI JV33-260 - Page 133

4-13
Printing on Double Side
1
2
3
4
Double Sided Printing
6
13
Adjust misalignment of scan direction on both sides.
• Ptess the keys and adjust the position.
14
Press the key.
15
Adjust the misalignment of the feed direction.
• Ptess the keys and adjust the position.
16
Press the key.
• Printing on the back side starts.
• When translucent media is selected, the Misalignment recheck line is printed before image data.
• If the scan direction is misaligned after checking the recheck line, press the key to stop printing,
and follow from the Step 1 again.
• Depending on media types, you cannot check the misalignment visually since the front line cannot be
seen from the back. In this case, slit up on the reference position with a cutter, measure the length to the
check line, and then input the difference with the jog key.
• Depending on media types, you cannot check the misalignment visually since the front line cannot be
seen from the back. In this case, slit up on the reference position with a cutter, measure the length to the
check line, and then input the difference with the jog key.
BackP r i n t POS . COMP .
Y:+ < 1.3mm > -
No misalignment
(No need to adjust)
Front
Adjust to minus direction.
If 1 mm misaligned, press
key to adjust -1mm.
Misalignment check line for scan direction
Back
Adjust to plus direction.
If 1 mm misaligned, press
key to adjust +1mm.
BackP r i n t POS . COMP .
X:+

1.3mm  -
No misalignment
(No need to adjust)
Front
Adjust to minus direction.
If 1 mm misaligned, press
key to adjust -1mm.
Misalignment check line
Back
Adjust to plus direction.
If 1 mm misaligned, press
key to adjust +1mm.