ii
CHAPTER 2 Basic Operations
User type ................................................................ 2-2
Set items registrable to User type ................................ 2-2
Using the registered user type ..................................... 2-2
Workflow ................................................................ 2-3
Turning the power ON/OFF ................................... 2-4
Turning the power ON ................................................. 2-4
Turning the power OFF ................................................ 2-5
Setting medias ....................................................... 2-6
Adjusting the head height ............................................ 2-6
Note for media setting .................................................. 2-8
Setting a heavy-duty roll media ................................... 2-9
Setting a narrow roll media ........................................ 2-20
Narrow take-up device ............................................... 2-25
Setting leaf media ...................................................... 2-26
Changing the printing origin ....................................... 2-28
Preparing Heaters ................................................ 2-30
Changing temperature settings of Heater .................. 2-30
Confirming the Heater temperature ........................... 2-31
Test printing ......................................................... 2-32
Perform test printing with the normal test pattern ...... 2-33
Perform test printing with the test pattern for checking
white ink ..................................................................... 2-34
Check warning of white nozzle status
(Only when using SS21 white ink) ............................. 2-35
Head Cleaning ..................................................... 2-36
About head cleaning .................................................. 2-36
Perform head cleaning depending on the test printing
result .......................................................................... 2-37
Perform spot color maintenance ................................ 2-37
Drawing data ........................................................ 2-40
Starting the print ........................................................ 2-40
Stopping the print temporarily .................................... 2-41
Erasing the received data (Data clear) ...................... 2-41
Cutting a media .......................................................... 2-42
To Next Page
Loading...
Need help?
General
