iv
To use sublimation transfer ink with more stable
quality ................................................................... 3-44
To prevent color change ............................................ 3-44
Note on head height adjustment ................................ 3-45
Confirming machine information .......................... 3-46
Displaying Information ............................................... 3-46
CHAPTER 4 Double Sided Printing
Printing on Double Side ......................................... 4-2
Workflow of double sided printing ................................ 4-2
Printing Area for double sided printing ......................... 4-3
Printing on Front Side .................................................. 4-5
Setting the Double Side Mode ..................................... 4-8
Printing on Back Side ................................................ 4-10
CHAPTER 5 Routine Maintenance
Maintaining ............................................................. 5-2
Precautions in cleaning ................................................ 5-2
Notes on cleaning solution ........................................... 5-2
Cleaning exterior surfaces ........................................... 5-3
Cleaning the platen ...................................................... 5-3
Cleaning of after heater cover and pre heater cover ... 5-3
Cleaning the media sensor .......................................... 5-4
Cleaning the media press ............................................ 5-4
Maintaining Capping station ................................... 5-5
Cleaning the wiper and ink caps .................................. 5-5
Replacing the wiper ..................................................... 5-7
Prior to Pump tube washing ......................................... 5-8
Washing of Head nozzle ............................................ 5-10
Cleaning the ink discharge passage
(PUMP TUBE WASH) ................................................ 5-12
When not using for a long term (CUSTODY WASH) . 5-14
Cleaning heads and surroundings parts .............. 5-16
When Nozzle clogged after cleaning ................... 5-18
Filling up ink ............................................................... 5-18
DISCHARGE & WASH .............................................. 5-19
Initial ink fill up ........................................................... 5-21
If dots misalign ..................................................... 5-23
To Next Page
Loading...
