Chapter 3 Adjustment > Mechanical Adjustment>Carriage Adjustment
108
6. Set the head height adjustment lever to the "LOW" position.
7. Move the carriage slowly.
• Move the side panel on the right-hand side of the carriage to the slit line on the platen.
Platen
Carriage side panel
Slit line
8. Loosen the screws (×1 each) on the adjustment lever.
9. Insert thickness gauges between the head guard plate and the platen.
10. Rotate the adjustment lever to adjust so that the gap between the head guard plate and platen falls
within the specified range.
• Specified value: 2.75 ±0.05 mm
• Rotate the adjustment lever downward: Raises carriage
• Rotate the adjustment lever upward: Lowers carriage
To Next Page
Loading...
