Chapter 3 Adjustment > Mechanical Adjustment>Carriage Adjustment
109
11. After adjusting, tighten the two adjustment lever screws.
12. Tighten the two head lock screws.
13. Check to confirm that it is within the specified value.
• Make adjustments repeatedly until the gaps are within the specified range at the left and
right measuring locations on the underside of the carriage.
14. Follow the procedure in the reverse order for assembly.
15. Perform "3.1.4 Jam Sensor Unit Height Adjustment"(P. 114).
16. Perform "3.2.3 Capping"(P. 134).
3
To Next Page
Loading...
