MIMAKI TS100-1600 - Preparing RIP Data

Chapter 2 Replacement of Maintenance Parts > Drive Related>Y Drive Pulley/Timing Belt
67
6. Detach the belt retainer on either the left or right side of the Y Drive Belt and separate from the belt.
Belt holder
Belt retainer
7. Remove the screw on the Y drive pulley.
• Do not remove the Y Drive Belt.
8. Remove the D BKT U.
D BKT U
9. Loosen the Y-drive motor belt tension retaining screws to relieve belt tension.
O-ring
Y drive pulley
10. Remove the O-ring on the top of the Y drive pulley.
• Be careful to avoid misplacing the O-ring.
11. Remove the Y Drive Belt and timing belt, then remove the Y drive pulley.
2