MIMAKI TS100-1600 - Maintenance Menu

Chapter 2 Replacement of Maintenance Parts > Ink Supply Related>Print head
77
12. Remove the following screws:
Remove
Remove
Avoid touching !
Avoid touching !
Remove
Remove
13. Remove the Head.
• Lift while rotating around the locating pin in the direction indicated by the arrow.
[ Top view ]
Locating pin
Compression
spring
14. Remove the new Head from the blister pack.
• If the rubber stopper is attached to the damper slot in the head, use radio pliers to remove
the rubber stopper.
15. Check to confirm that grease (--- MISSING LINK ---) is applied to the head base.
Long hole inside
Locating pin side
Do not apply grease in the screw holes.
• Slant deviation may occur during stagger adjustment if grease is not applied.
16. Attaching the new Head and connect the connectors.
17. Turn on the main power supply and press the [END/POWER] key.
• If a head-related error occurs, check the connector connections. "6.2 Error List"(P. 175)
18. Dispose of the ink in the waste ink tank and reset the waste ink tank counter.
19. Clean the Head.
• Reference: "Head unit flushing"(P. 144)
2