Mindray A5 - Page 96

Display Tab System Interface
3 - 36 046-003777-00 A5/A3™ Operating Instructions
4. Select the Accept button to confirm the change, or select Cancel button to discard the
change.
Plimit Line
The Plimit line function displays a dashed line in the Pressure waveform area to indicate the Plimit
position. The Plimit line can be displayed in VCV, SIMV-VC, and PCV with VG on mode. The Plimit line
function can be switched On or Off by the user. The default value for Plimit Line is On.
FIGURE 3-43 Plimit Line
NOTE: The Plimit line does not affect the auto-scaling algorithm. If the
Plimit line is turned on but not visible, it may be because the
line is positioned off the waveform scale.
To set the Plimit Line to ON or OFF:
1. Select Setup softkey > Display tab.
2. Select the Plimit Line button to ON or OFF.
3. Select the Accept button to confirm the change, or select Cancel button to discard the
change.
CO
2
Placement (with an AG module connected)
The CO
2
waveform/data can be positioned at the top or bottom of the Waveform area.
To set the CO
2
placement:
1. Select Setup softkey > Display tab.
2. Select the CO
2
Placement button.
3. Select Top or Bottom.
4. Select the Accept button to confirm the change, or select Cancel button to discard the
change.
CO
2
Scale (with an AG module connected)
The CO
2
scale of the CO
2
waveform can be adjusted to one of three settings. The table below shows
the CO
2
scale options.
To set the CO
2
scale:
1. Select Setup softkey > Display tab.
2. Select the CO
2
Scale button.
Plimit Line