Information and Care
Pressurisation
The camera module must always be correctly lled with CO
2
or Nitrogen.
The control unit displays the internal pressure.
Cleaning
Ensure the camera module is thoroughly cleaned after each inspection.
Ensure the connector is free from dirt and moisture. Always t the
protective cap immediately after disconnecting the camera module from
the system.
Maintenance
Ensure that all screw threads and connections are free from dirt. Replace
the rubber protectors when worn or damaged.
CAUTION!
High-pressure cleaners must not be used. It can cause
considerable damage to the crawler, camera and other
system components.
Cleaning agents or solvents must not be used. These can
damage the seals and other materials on the system.
Only clean water should be used.
112
Version LMinicam Proteus
To Next Page
Loading...