Checking Plug and Socket Connections
To ensure reliable operation it is important that the electrical connec-
tions are not
damaged and are kept clean and dry. It is important to check before and
after each use of the inspection system.
• Check the contacts on the camera back plate.
• Check the contacts on the crawler camera connector (with
care).
• Check the contacts on the crawler cable connector.
• Check the contacts on the cable reel connector.
• Check the contacts on the control unit.
• Check the contacts on the auxiliary module.
Clean dirt and moisture from the pins and connectors using an electronic
contact cleaner aerosol.
NOTE!
• Disconnect the power supply from the system.
• Check the O-rings for damage and replace if necessary.
• Grease the O-rings if necessary using O-ring lubricant.
29
Version L Minicam Proteus
To Next Page
Loading...
