MINICAM PROTEUS - Instructions for Pressurising the CPL150 S Crawler

Instructions for Pressurising the CPL150S Crawler
1 Connect the Proteus
™
Lite inspection system and apply power.
2 Unscrew the pressure valve protection cap (A) and screw on the
pressure valve connection adaptor (B).
3 Set the pressure regulator for the CO
2
or Nitrogen to 10 PSI.
4 Ensure the crawler pressure is within the acceptable range by checking
the pressure gauge on the control unit. An example is shown below.
Refer to the CCU section of this manual on specic instructions on how
to access the pressure gauges.
5 Remove the pressure valve connection adaptor (B).
6 Ret the pressure valve protection cap (A).
Image shows an example of the control unit crawler pressure gauge:
A
B
38
Version LMinicam Proteus