Cleaning
To minimise down time and subsequent repairs it is
necessary to keep your PROTEUS
™
inspection system clean.
Please follow the instructions below to help avoid disruption.
CAUTION!
Risk of fatal injuries caused by electrical current!
Ensure that no uids can enter the control panel or
penetrate the housing of the cable reel. If this happens,
immediately disconnect the power supply and inform the
Minicam Service Centre.
CAUTION!
Risk of fatal injuries caused by electrical current!
For all cleaning and maintenance work disconnect the
system from the power supply.
General cleaning work
CAUTION!
High-pressure cleaners must not be used. It can cause
considerable damage to the crawler, camera and other
system components.
Cleaning agents or solvents must not be used. These can
damage the seals and other materials on the system.
Only clean water should be used.
• Clean the crawler and camera with water after the rst
inspection. Only after this should you loosen electrical
connections.
• Immediately t the protective caps after removing
electrical
connections.
• Check O-rings for damage and replace if necessary and
grease regularly with O-ring lubricant.
27
Version L Minicam Proteus
To Next Page
Loading...
