Warnings, Safety Measures and Care
Please read the safety measures closely and observe them. They pre-
serve your own safety, the safety of co-workers as well as the prevention
of damage to the PROTEUS
™
inspection system and its components.
CAUTION!
The operator of the PROTEUS
™
inspection system must be
trained by either Minicam or one of its authorised
representatives before using the system.
CAUTION!
Despite all of the safety functions built into the system, the
operator is not exonerated in any way from his/her duty of
care. Thus the user alone is responsible for any damage
caused as a result of misuse.
CAUTION!
If the equipment is used in a manner not specied by the
manufacturer, the protection provided by the equipment
may be impaired.
DANGER!
Risk of deadly injuries from electrical current!
The mains plug and or IEC connector of the PSU is the supply
isolation device and must be easily accessible.
DANGER!
Risk of deadly injuries from electrical current!
• The power supply for the crawler can generate a high
voltage which can be considered hazardous, however this
supply cannot be switched on unless all parts of the system
are connected. Consequently this supply is not accessible,
and as soon as any connection is exposed or disconnected
the power supply will automatically shut o.
• This hazardous voltage may be exposed if the control unit,
cable
reel or crawler is opened while the system is operational.
Therefore
the modules of the system should only be opened
by a Minicam Service Centre.
20
Version LMinicam Proteus
To Next Page
Loading...
