Safety Measures
The sta assigned to tasks involving the PROTEUS
™
inspection system
must have read and understood this user manual completely before the
start of the work. This applies equally to the sta who only work on the
inspection system
infrequently, e.g. for maintenance, repair or retrotting work.
NOTE!
The operator of this inspection system is obliged to ensure a
safe and hazard-free operation. This may be achieved by the
following measures:
• Making the user manual available on the site of the use of
the inspection system at all times.
• Check lists for maintenance and care.
• Regular reviews of the safety and hazard conditions
NOTE!
Safety of persons!
The sta for operation, maintenance and upgrading must
have specialist expertise or be instructed by competent indi
viduals. Competent individuals must have adequate
knowledge of the PROTEUS
™
inspection system based on
technical training and experience. They must be familiar with
the relevant work safety regulations and accident prevention
rules to an extent that they are capable of judging the in
spection system operational safety.
They must:
• Observe the operating manual for the workplace.
• Observe the relevant work safety regulations and accident
prevention rules.
• Seek instruction for the handling of hazardous
substances.
• Adhere to the safety information described in this user
manual.
24
Version LMinicam Proteus
To Next Page
Loading...
