Problem Try this
Cable is getting tangled or run
over by crawler when reversing.
1. Check the CCU is using the
correct wheel size, see section
Selecting Crawler Wheel Size.
2. Adjust the Torque, see section
Rewinding.
Cable is very tight when crawler is
reversing.
1. Check the CCU is using the cor-
rect wheel size, see section
Selecting the Crawler Wheel
Size.
2. Adjust the Torque, see section
Rewinding.
No LEDs are on. Check all cable ttings and that
the CCU is powered on.
Troubleshooting
First, refer to this document’s section Status Display for the Motor-
ised Cable Reel page 80 – this shows common indications telling you
what’s wrong.
93
Version L Minicam Proteus
To Next Page
Loading...
