What to do if no LEDs are on MINICAM PROTEUS?
If no LEDs are lighting up on your MINICAM Analytical Instruments, first, ensure that the CCU is powered on. Then, check all cable fittings to confirm they are properly connected.
How to prevent cable from tangling when reversing MINICAM PROTEUS?
If the cable is getting tangled or run over by the crawler when reversing your MINICAM Analytical Instruments, take these steps: 1. Check that the CCU is using the correct wheel size. 2. Adjust the torque.
General| Camera Material | Stainless Steel |
|---|---|
| Sensor Type | CMOS |
| Dynamic Range | 60 dB |
| Light Source | LED (integrated) |
| Power Supply | 5V DC (via USB) |
| Frame Rate | 30fps |
| Interface | USB |
To Next Page
