This instruction manual is applicable to the PROTEUS
™
inspection system.
A standard system and available options are covered by this document.
Depending on your system conguration you may lack some of the fea-
tures mentioned in this
document.
Disclaimer
Hardware and software mentioned in this document are subject to
continuous development and improvement. Consequently, there may be
minor dierence between the information in the document and the
performance or design of the product. Specications, dimensions and
other statements in this document are subject to change without prior
notice.
Minicam and its suppliers shall not be liable for any damages related to
this software or hardware, or for any other damages whatsoever caused
by the use of or inability to use any Minicam product. This is applicable
even if Minicam has been advised of the damage risk. Under any circum-
stances, Minicam’s entire liability shall be limited to replace such defective
software or hardware that was originally purchased from Minicam.
Minicam Limited
Raven Locks, Ravenscraig Road, Bolton, United Kingdom, M38 9PU
Tel: +44 (0)1942 270524 Email: info@minicam.co.uk
www.minicamgroup.com
Company Registered in England & Wales • Company Registration No: 3728693
To Next Page
Loading...