Maintenance
To ensure the maximum service life of the PROTEUS
™
inspection system
the individual modules and accessories belonging to the system have to
be independently maintained and kept clean. Moving parts, in particular,
can have improved operational life by frequent professional cleaning
after inspections. Also, the risk to the operator of infection can be signi-
cantly reduced by using a cleaned system.
Take notice of the following comments on general maintenance:
• Keep the entire system clean and clean the system directly after
each inspection.
• Thoroughly wash down the parts of the system that have come
into contact with moisture and then dry them with a clean and
dry cloth.
• Keep all electrical connections and contacts free of dirt, grease
and moisture at all times.
• Never bend the cable of the system and avoid knots.
• Clean the cable with a rag when retracting.
• Regularly grease all exposed O-rings using O-ring lubricant as
required in the maintenance instruction.
• Use only suitable display cleaners for cleaning the display as
required in the maintenance instruction.
• Use only clean and dust free cloths for cleaning the display.
• Use water for cleaning without the addition of cleaning
agents or solvents.
For detailed maintenance instructions for individual modules
and accessories please read the comments in the description
for each
module. The specic maintenance work steps will
also be explained.
NOTE!
The operator of the system is responsible for the proper
disposal! See information on page 192 on the return of
equipment at the end of the useful life.
26
Version LMinicam Proteus
To Next Page
Loading...