Operating Conditions
84
Main Menu -> Event Log -> Clear Event Log
This option requires access level 2.
If this option is selected while the system is not set at access level 2, the LCD displays the following message:
Permission denied, access level too low
PRESS Continue
To gain access to level 2, refer to the next section (going to access level 2).
Select 3 from the Event Log Menu. The following message displays:
Clear Event Log?
Press Enter to clear, Exit to cancel
Pressing Enter clears all the events stored in the Event Log. The following message displays:
Event Log cleared
Use Continue to return to event log menu
Main Menu -> Access Level
Access Level 2 is required to use the Service, Isolate, and the Clear Event Log options.
Select 2 from the Main Menu. The LCD displays:
Enter password: *******
EXIT - Return to Main Menu
Use the numeric keypad to enter the password. Asterisks (*) appear as you type in your password - seven characters long.
After entering all digits, the LCD displays the following message:
Access level will be set to 2
USE: Enter to confirm, Exit to cancel
Entering access level 2 causes the Controls Enabled LED to flash.
If, on the other hand, you have entered an incorrect password, the LCD displays the following message:
Password incorrect, Access level still 1
PRESS: Continue to retry, Exit to quit
1) The Controls Enabled indicator always shows the current access level. LED off: Access Level 0. LED steady: Access
Level 1. LED flashing: Access Level 2.
2) If no push button is depressed for a period of 5 minutes, the system automatically returns to Access Level 1.
To Next Page
Loading...
