2. CNC Monitor Screen
2.3(II) Tool Offset (M system)
(Refer to "2.3 (I). Tool Offset (L system)" for Lathe system)
I - 81
2.3.2.3 Tool Registration in HEAD, NEXT, and INDEX
This fu
nction is used to change display data when the tool number set in magazine pot differs from the
displayed tool number.
Set in HEAD MG (SP) TOOL ( )
Set in NEXT 1 MG (N1) TOOL ( )
Set in NEXT 2 MG (N2) TOOL ( )
Set in NEXT 3 MG (N3) TOOL ( )
Set in INDEX MG (N4) TOOL ( )
Set “SP” in MG ( ) and
"10" in TOOL ( ).
Press the [INPUT] key.
"10" is displayed below HEAD in the data display area and a
change is made to MG (N1) in the data setting area.
(Note) Although the title display on the screen top (HEAD, NEXT 1 to NEXT 3, INDEX) varies depending
on the machine manufacturer, data is set by using SP And N1 to N4.
2.3.2.4 Tool Registration Data Clear
Set “CL
”
in MG ( ).
Press the [INPUT] key.
ll data displayed in HEAD, NEXT 1
to NEXT 3, INDEX, and MG1 to
MGn is cleared.
To Next Page
Loading...
Need help?
General
