2. CNC Monitor Screen
2.3(II) Tool Offset (M system)
(Refer to "2.3 (I). Tool Offset (L system)" for Lathe system)
I - 70
2.3(II) Tool Offset (M system)
The following menu will display if the function selection key [TOOL PARAM] is pressed.
BACK NEXT
BACK NEXT
PARAM menu display(No.1 to 4)
TOOL menu display(No.1 to 4)
OFFSET REGIST LIFE MENU
Menu selection ke
Previous
a
e ke
Next page key
WORK PROCESS SETUP MENU
(Note)
WORK
OFFSET
PROCESS
PARAMETER
CONTROL
PARAMETER
AXIS
PARAMETER
(Note) "WORK" is included in the TOOL menu.
CAUTION
If a tool offset amount is changed during automatic operation (including during single block stop),
the new offset is validated from the command of the next block or blocks onwards.
To Next Page
Loading...
