Mitsubishi C70 User Manual

2. CNC Monitor Screen
2.3(II) Tool Offset (M system)
(Refer to "2.3 (I). Tool Offset (L system)" for Lathe system)
I - 87
Display item Explanation Setting range
L-CMP
R-CMP
These depend on the data format specified in FORM. Compensation
number:
1 to 400
Addition
compensation
amount:
±1 to 99999.999
Direct compensation
amount:
±1 to 99999.999
AUX This depends on the machine manufacturer
specifications.
0 to 65535
LIFE Life of each tool. It is displayed in the use time
(minutes), mount count (the number of times the tool
has been mounted on the spindle), or work count (the
number of times drilling has been performed) as
specified in FORM.
If it is set to 0, life infinity is specified.
Use time:
0 to 4000 (min)
Mount count:
0 to 9999 (times)
Work count:
0 to 9999 (times)
USE Use data of each tool is displayed in the form as
specified in FORM (a. Tool life control mode).
(Note) Use data is not counted during machine
lock, miscellaneous function lock, dry run,
or single block mode.
Use time:
0 to 4000 (min)
Mount count:
0 to 9999 (times)
Work count:
0 to 9999 (times)
(Note) The No. of uses/No. of mounts depends on the model.

Mitsubishi C70 Specifications

General

Brand	Mitsubishi
Model	C70
Category	Control Unit
Language	English