CAUTION
The electrolytic capacitor and fan will deteriorate. Periodically change these to prevent
secondary damage from faults. Replacements can be made by our sales
representative, or at the nearest service center.
If an error occurs in the self diagnosis of the controller or servo amplifier, confirm the
check details according to the instruction manual, and restore the operation.
If a dangerous state is predicted in case of a power failure or product failure, in order
to prevent that state, use a servomotor with electromagnetic brakes for maintenance
or mount a brake mechanism externally.
Use a double circuit construction so that the electromagnetic brake operation circuit
can be operated by emergency stop signals set externally.
MBR
EMG
24VDC
If an error occurs, remove the cause, secure the safety and then resume operation
after alarm release.
The unit may suddenly restart after a power failure is restored, so do not go near the
machine.
(Design the machine so that personal safety can be ensured even if the machine
restarts suddenly.)
Confirm and adjust the program and each parameter before operation. Unpredictable
movements may occur depending on the machine.
Extreme adjustments and changes may lead to unstable operation, so never make
them.
Do not apply a voltage other than that specified in the instruction manual on any
terminal. Doing so may lead to destruction or damage.
Do not mistake the terminal connections, as this may lead to destruction or damage.
Do not mistake the polarity (+ / -), as this may lead to destruction or damage.
10. Items related to servo/spindle parameters
Do not make remarkable adjustments or changes of the parameters as the operation
may became unstable.
To Next Page
Loading...
Need help?
General
