Appendix 6. Operation Messages on Setting Display Unit
Appendix 6.3 Dialog Error Messages on Input/Output Screen
IV - 35
Function Target Error message Cause of error
CAN'T DELETE FILE
The file is a parameter file, etc., and cannot be
deleted.
DIRECTRY ERROR The directory does not exist or was not designated.
FILE NOT FOUND The file was not found.
FILE NAME FORMAT ILLEGAL The file name format is illegal.
UNABLE TO DELETE : PROGRAM
RUNNING
The file cannot be deleted. (The file is running.)
FILE-SYSTEM ERROR. PLEASE DO SETUP
PROCESS
There is an error in the file system.
DATA PROTECT The data is protected.
UNABLE TO DELETE : PLC RUNNING Cannot delete because the built-in PLC is running.
NC
Can't write file because other data in/out
function is accessing this NC. Please try
again later.
Another input/output function is being executed via the
network.
CAN'T DELETE FILE A file that does not exist on the PC was required to be
deleted.
DIRECTRY ERROR The designated directory is not in the PC.
FILE NOT FOUND The designated file does not exist.
DRIVE NOT EXIST The designated drive was not found in the PC.
DIRECTRY ERROR The directory was not found.
FILE NOT FOUND The file was not found.
CAN'T OPEN FILE The directory could not be opened.
TRANSFER ERROR : SOURCE FILE Calling of the file information failed.
Delete
Memory
card
DRIVE NOT EXIST The drive does not exist.
To Next Page
Loading...
Need help?
General
