Mitsubishi C70

IV - 49
Appendix 7. Explanation of Alarms
Appendix 7.1 Operation Errors (M)
M01 Mixed sync ctrl disable modal 1035
Details
Mixed control (cross axis control) was commanded for a part system in which the mixed
control (cross axis control) is disabled as shown below.
- During nose R compensation mode
- During pole coordinate interpolation mode
- During cylindrical interpolation mode
- During balance cut mode
- During fixed cycle machining mode
- During facing turret mirror image
- During constant surface speed control mode
- During hobbing mode
- During axis name switch
Remedy
- Correct the program.
M01 Synchro ctrl setting disable 1036
Details
"Synchronous control operation method" was set (with R2589) when the mode was not the
C axis mode.
"Synchronous control operation method" was set (with R2589) in the zero point not set state.
Mirror image is disabled.
External mirror image or parameter mirror image was commanded during facing turret mirror
image.
Remedy
- Set the contents of the R2589 register to "0".
- Correct the program and parameters.
M01 Synchro start/cancel disable 1037
Details
Synchronous control start/cancel command was issued when the start/cancel is disabled.
Remedy
- Correct the program and parameters.
M01 Move cmnd invld to synchro ax 1038
Details
A travel command was issued to a synchronous axis in synchronous control.
Remedy
- Correct the program.
M01 External spindle speed clamp speed zero 1039
Details
External spindle speed clamp signal has been turned ON while the clamp speed has not
been set.
Remedy
- Set the external spindle speed clamp feedrate parameter.
- Turn OFF the external spindle speed clamp signal.