CAUTION
1. Items related to product and manual
For items described as "Restrictions" or "Usable State" in this manual, the instruction
manual issued by the machine manufacturer takes precedence over this manual.
An effort has been made to describe special handling of this machine, but items that
are not described must be interpreted as "Not Possible".
This manual is written on the assumption that all option functions are added. Refer to
the specifications issued by the machine manufacturer before starting use.
Refer to the manuals issued by the machine manufacturer for each machine tool
explanation.
Some screens and functions may differ or may not be usable depending on the NC
version.
2. Items related to installation and assembly
Always ground the signal cable to ensure stable operation of the system. Ground the
NC unit, power distribution panel and machine to a one-point ground to establish the
same potential.
3. Items related to preparations before use.
Always set the stored stroke limit. Setting no limits could result in collision with the
machine end.
Always turn the power OFF before connecting/disconnecting the input/output device
cables. The NC and input/output device could be damaged if the cable is connected
in the power ON state.
4. Items related to screen operation
If the tool compensation amount is changed during automatic operation (including
single block stop), the amount will be validated from the next block or several blocks
following.
If the workpiece coordinate offset amount is changed during single block stop, the
changes will be valid from the next block.
Pay close attention to the sequence operation when carrying out forced data setting
(forced output) in the PLC I/F (diagnosis) screen.
If the operation start position is set from a block in the program and the program is
started, the program before the set block is not executed. If there are coordinate
system shift commands or M, S, T, and B commands before the block set as the
starting position, carry out the required commands using the MDI, etc. There is a
danger of interference with the machine if the operation is started from the set starting
position block without carrying out these operations.
To prevent the influence of data loss and data transformation over the line, always
carry out data comparison after transferring a machining program.
Do not change the setup parameters without prior consent from the machine
manufacturer.
To Next Page
Loading...
Need help?
General
