Mitsubishi S12A2 - Page 262

10-20
Chapter 10 COOLING SYSTEM
(7) Fit the snap ring in the groove on the inner periphery of
the tension pulley.
Snap Ring - Install
(8) Install the outside spacer.
Outer Spacer - Install
(9) Install the thrust plate with bolt.
Thrust plate - Install
(10)Tighten the bolt.
Note: After assembly, confirm that the tension pulley rotates
smoothly.
Bolt - Tighten
Snap ring
Spacer
Thrust plate
Bolt
98 N·m
{10 kgf·m}
[72 lbf·ft]