Mitsubishi S12A2 - ADJUSTMENT AND OPERATION

13-1
Chapter 13 ADJUSTMENT AND OPERATION
1. Engine - Adjust ......................................................................................................13-3
1.1 Valve Bridge and Adjusting Screw - Check ............................................................................ 13-3
1.2 Valve Clearance - Check........................................................................................................ 13-3
1.3 Fuel Injection Timing - Check ................................................................................................. 13-3
1.4 Fuel System - Bleed Air.......................................................................................................... 13-3
1.5 Belt and Belt Tension - Inspect and Adjust............................................................................. 13-6
2. Break-in Operation ..............................................................................................13-10
2.1 Preparation Before Engine Starting...................................................................................... 13-10
2.2 Engine Start-up..................................................................................................................... 13-10
2.3 Break-in Operation................................................................................................................ 13-10
3. Engine-Test and Adjustment..............................................................................13-12
3.1 Engine Performance Test..................................................................................................... 13-12
3.2 Emission Gas Test................................................................................................................ 13-12
3.3 Governor Performance Test ................................................................................................. 13-12
3.4 Alarm Action and Emergency Stop Tests............................................................................. 13-12
3.5 Maximum Fuel Injection Volume - Set.................................................................................. 13-12
3.6 Seal ...................................................................................................................................... 13-13