Mitutoyo SJ-301 - Page 123

5 - 25 No. 99MBB091A
5. MODIFYING THE MEASUREMENT CONDITIONS
■ Modifying the measuring range
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
 m
 m
CARD
F1 F2 F3 F4
Condition menu
STAND
PROFILE
FILTER
c
s
N
EVA-L
RE-CAL.
JIS'94
R
GAUSS
4.0mm
5
0.8mm
2.5
m
Page1/3
P
RANGE
AUTO
10 50
100 350
ESC
GO
N5
Condition menu
STAND.
PROFILE
FILTER
c
s
EVA-L
RE-CAL.
JIS'94
R
GAUSS
4.0mm
0.8mm
2.5m
Page1/3
0.5mm/s
ON
Page2/3
GO/NG
mm/inch
CUST.
mm
RANGE AUTO,ESC
RE-CAL.
Condition menu
1
2
3
4
[Page1/3]
[RANGE]
Home screen
Measurement Condition Setup screen (1/3)
Measurement Condition Setup screen (2/3)
[Condition]
Measuring Range Setup window
Range buttons
Buttons for remedying
an over-range error.
Touch the [Condition] button in the Home screen.
The Measuring Condition Setup screen(1/3) will appear.
Touch the [Page 1/3] button.
The Measuring Condition Setup screen(2/3) will appear.
Touch the [RANGE] button.
The Measuring Range Setup screen will appear.
Touch the button of the range to be set.
The touched range button will be highlighted.
Touch the button for remedying an over-range error.
[ESC] :
Aborts the measurement if an over-range error occurs.
[GO] :
Continues the measurement if an over-range error occurs.
TIP If the [GO] button is selected, measurement
can continue even if an over-range error occurs
during measurement. However, the calculation
result may not be correct. Should an over-
range error occur, 夽 will be displayed next to
the resultant data.