Mitutoyo SJ-301 - Setting the Calculation Conditions if Mr[C] Is Selected

5 - 42 No. 99MBB091A
5.10.3 Setting the calculation conditions if mr[c] is selected
If the parameter mr[c] is selected, the slice level must also be set as a calculation condition.
TIP The set calculation condition is displayed on the Home screen as illustrated below.
Level of the slice line
Reference kind (P: Peak reference, B: Base reference)
Rmr[c]
(
P,10%
)
NOTE For the peak reference, set the slice level between 0 and 100% or 0 and 999.9m.
If the minus value is entered, the slice level is automatically set at 0% or 0m.
■ Transition of screens if the calculation conditions are set for mr[c]
mr[c] Measurement Condition
Setup window
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.83
7.12
2000-01-01
 m
 m
CARD
[Home] [Enter]
Home screen
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
CAL.
1.54
2000-01-01
%
 m
CARD
mr[c] Slice Level Input screen
Rmr[c] Slice Level
(-100 100%)
4 5 6
%
7
10
BS
AC
8 9
1 2
0 .
3
ESC
Parameter
button
[S. LEVEL]
button
Rmr[c]
Ra
(
P,10%
)
15
F1 F2 F3 F4 F1 F2 F3 F4
Rmr[c]
BASE
S.LEVEL
PEAK
10 %