Mitutoyo SJ-301 - Starting Measurement

No. 99MBB091A 4 - 12
4.3.2 Starting measurement
■ Measurement procedure
1 <Home screen>
<Home screen>
[START/STOP] Key
START
STOP
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
 m
 m
CARD
2000-01-01
Measuring
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.57
8.12
2000-01-01
 m
 m
CARD
2000-01-01
Measuring
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
F1 F2 F3 F4
F1 F2 F3 F4
Press the [START/STOP] key at the display of the Home
screen.
The Detector traverses, performing measurement. A bar is
displayed indicating the measurement is in progress.
After the measurement has been completed, a bar appears
indicating the calculation is in progress, during which the
Detector returns to the origin point.
Upon completion of calculation, measured results will be
displayed. The display of the measurement data can be
switched to that of the measured profile. Also, the display
parameter can be switched.
TIP Refer to “4.4 Switching the measured results
display” if displaying the measured profile or
switching the parameters.